MACO MAGNETIC DISPLAY SYSTEM MAG-PAINT SPECIFICATION SHEET METAL GREY MACO MAG-PAINT FEATURES AND ADVANTAGES magnet to stick to it. High permeability raw materials 2 coats are recommended to provide maximum magnetic holding force. Water-based formula with low VOC non-Formaldehyde non-toxic odorless raw materials Applicable scope interior use surface area should be dry smooth and clean before painting. Recommended working condition temperature above 55 deg. F Application Procedure Metal grey appearance with fine smooth texture. thick paint with clean short wool brush add additional coats depending on magnetic strength Easy to apply dries quickly and cleans up with water. STANDARD SIZE Part No. Volume N.W. MPAINT-MG080 0.8L 1.53kg MPAINT-MG1GAL PACKAGING 0.25L wipe the surface with a wet towel and allow to dry. Roller painting clean the working area stir the paint thick apply paint with clean rolleradd additional coats depending on magnetic strength needed sand 7.64kg 1 gallon 4.55L needed sand final coat with 320 grit sandpaper and well do not add more than 5 water if paint is too 0.48kg 4L Brush painting clean the working area stir the paint well do not add more than 5 water if paint is too Interior use waterproof and made of anti-rust materials MPAINT-MG400 NO NMEQS-MACO 178 NOTES Mag-paint is a magnetic receptive paint that causes a MPAINT-MG025 Edition A0 20lbs final coat with 320 grit sandpaper and wipe the surface with a wet towel and allow to dry. Spray painting clean the working area stir the paint well do not add more than 8 water if paint is too thick Use a 1.5mm spray nozzle add additional seal in PE bag put in plastic can PHYSICAL DATA Liquid Density 67 ounces Pint Smell Coverage Appearance Color coats depending on magnetic strength needed sand Metal grey Odorless Covering Area 100 sq. ft.gal Lifting Weight 88 lbs. sq. ft. Condition the standard test tool is isotropic rubber magnet 0.028 mil. Test equipment is Tensile Strength Tester
. surface with a wet towel and allow to dry. Surface dry time 10min 74 deg. F 50RH Painting interval allow 4 hours between coats and 24 hours before applying standard wall paint or magnets. Coverage area approximately 100 square feet per gallon. 100 sq. ft. per gallon MAGNETIC DATA final coat with 320 grit sandpaper and wipe the PROCESS AND STORAGE Storage store indoor in temperatures above freezing and below 90 degrees. Shelf life 6 months under storage conditions. Un-used material should be sealed immediately after use Metal powder may settle to bottom of container during storage. Stir well before using paint.
