See Through Substrate Disinfectant Solutions
Plastic Disinfectant Guidelines These general guidelines are focused on household cleaners and are meant for the general public. Following the suggested guidelines may result in reducing the survival of bacteria and viruses in these environments however the risk of transmission is always present. Cleaning refers to the removal of germs dirt and Bleach Compatible with Optix Acrylic Vivak PETG Prepare household bleach solution by mixing 5 tablespoons 13 cup bleach per gallon of water or 4 teaspoons bleach per quart of water Diluted bleach is not stable and should be prepared impurities from surfaces. It does not kill germs but by removing them it lowers their numbers and the risk of spreading infection Disinfecting refers to using chemicals for example EPA-registered disinfectants to kill germs on weekly from concentrated stock surfaces. This process does not necessarily clean dirty Follow manufacturers instructions for application. surface after cleaning it can further lower the risk of Contact time typically measured in minutes Isopropyl Alcohol IPA or Ethyl Alcohol Compatible with Vivak PETG Tuffak Polycarbonate Use of alcohol based wipes sprays or soaked cloths containing at least 70 alcohol. Do not dilute Fast acting. Allow alcohol to remain on surface for at least 30 seconds or longer to disinfect Hydrogen Peroxide Compatible with Optix Acrylic Vivak PETG Tuffak Polycarbonate Use 3-5 hydrogen peroxide do not dilute. Allow to remain on surface for several minutes surfaces or remove germs but by killing germs on a spreading infection Wear disposable gloves when cleaning and disinfecting surfaces. Gloves should be discarded after each use If surfaces are dirty they should be cleaned using a gentle warm dish washing soap and rinsed with clean water prior to disinfection. Use of microfiber cloths cleans 50 better than comparable cotton towels and reduces the risk of scratching plastic. Allow enough contact time after applying the Warm Soapy Water Compatible with
Optix Acrylic disinfectant. If the contact time is too brief the Vivak PETG Tuffak Polycarbonate surface will not be thoroughly disinfected. Vigorously wash the surface with dishwashing soap for a minimum of 20 seconds or longer then rinse with clean water SPECIAL NOTES Polycarbonate and acrylic products were tested on uncoated sheets. Do not use unapproved cleaners or disinfectants on sheet products. Generally speaking hydrogen peroxide and isopropyl alcohol-based sanitizers work best as disinfectants on polycarbonate and acrylic. Disinfectants containing hydroxides dimethyl benzyl or ethyl ammonium chloride ethylenediamines and hypochlorite will crackcraze the polycarbonate sheets. Because manufacturers sometimes change their formulas without notification compatibility in perpetuality cannot be presumed. Visit our website To find your local branch www.piedmontplastics.com 6.13.19 REV. 1